Δέκτες, Modules

FrSky Futaba FASST Compatible 4Ch 2.4Ghz Receiver

FrSky Futaba FASST Compatible 4Ch 2.4Ghz Receiver
  • Κωδικός/Model: FRSKY TFR4B
  • Βάρος Μεταφοράς: 0.1Kgr
  • Διαθεσιμότητα stock level
  • Κατασκευάζεται από: FrSky

30.00€

Πρόσθεσε :         

1.Introduction
1.1 Compatibility:
FASST 2.4G: Air Systems (7CH Mode/Multi Mode) & Surface Systems (C1 Mode)
FrSky TF Modules: TF-8M, TF-14M
1.2 Specifications:
Number of Channels: 4
Operating Voltage Range: 3.5V~10V
Operating Temperature Range: -10℃~80℃
Dimension: 42*17*7mm
Weight: 4.6g
1.3 Features
1) Compatible with FASST 2.4G: Air Systems (7CH Mode/Multi Mode) & Surface Systems (C1 Mode);
2) CPPM and RSSI (PWM) output - If CH3 and CH4 are connected by a jumper, CH1 will output CPPM for CH1~CH8, and CH2 will output RSSI (PWM);
3) Lighter weight and physically smaller;
4) Two selectable failsafe setting options.
 
2.Setup
2.1 Bind procedure:
Turn on the transmitter, connect the battery to the receiver while pressing receiverΆs F/S button. After the RED LED is off and GREEN LED is solid, the binding process is completed and the receiver is operating normally.
2.2 Setting failsafe:
TFR4-B support two selectable failsafe setting options, either use native failsafe position preset on the transmitter side, or set failsafe on TFR4-B.
2.2.1 Use native failsafe position preset on the transmitter side:
If not disabling failsafe on the transmitter side, TFR4-B will use native failsafe position preset on the transmitter side.
2.2.2 Set failsafe on TFR4-B side:
TFR4-B supports failsafe function for all channels. Follow the steps below to set failsafe on TFR4-B:
1) Bind the receiver first, and disable failsafe on the transmitter side;
2) Set all transmitter controls to the desired failsafe position;
3) Press briefly the F/S button of the receiver, the GREEN LED of the receiver will flash twice, indicating the failsafe is set up successfully.
If you do not need the failsafe function any more, just re-bind the receiver to set default failsafe mode.
Hint: If not disabling failsafe on the transmitter side, TFR4-B will use native failsafe position preset on the transmitter side.
2.3 LED status:
RED LEDGREEN LEDMode
OffOnNormal mode
OnOnWaiting to be bound
FlashingOnSignal lost
OnFlashing twiceSet failsafe
 
3. How to get CPPM and RSSI from TFR4-B
If CH3 and CH4 are connected by a jumper, CH1 will output CPPM for CH1~CH8, and CH2 will output RSSI (PWM).

Υπάρχουσες Κριτικές: 0


Πελάτες που αγόρασαν αυτό το προϊόν επίσης αγόρασαν